MICROLINE 721 DRIVER

Each character has five bars and four spaces. Page 45 Here is a summary of the buttons active in the Menu Mode: The movement of the left tractor is limited to ensure that the paper will always contact the paper sensor when loaded. Lower front of cartridge over printhead until it snaps into place, then turn knob in direction of arrow clockwise to take up ribbon slack. Load this quadruple-thick sheet onto tractor pins and close tractor covers. Always turn the printer off before you turn the platen knob!

Uploader:	Nitaur
Date Added:	18 April 2012
File Size:	65.56 Mb
Operating Systems:	Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads:	11187
Price:	Free* [*Free Regsitration Required]

Prints list of all Menu settings for current emulation. Accessories You can add even more flexibility to your printer by means of the following optional accessories.

Overview | MICROLINE Plus | 9 Pin Dot Matrix Printers | OKI Data Australia

Page 21 Loading Rear-Feed Paper The rear-feed paper path is recommended for single-thickness, continuous fan-fold paper when printing spreadsheets, long reports, etc. If you have any continuous-form paper in the paper path, you must press the PARK button on the front panel to remove it from the path before lading single sheets. Make sure the printer is unplugged before you install the micfoline. Interface cable and paper are sold separately.

Reload regular paper open tractor covers, place paper on pins, close tractor covers. To load continuous-form paper from the rear: Remove the protective material.

Selecting Character Pitch Character Pitch button The character pitch determines the width of the individual characters and is measured in characters per inch cpi.

If form tear off is being selected in the printer menu, press the TEAR button to bring the paper down to the print position. Adjust paper feed guides for width of paper and drop sheet of paper into separator.

Pin assignments for the parallel, USB and the serial interfaces are listed in appendix E. Pull paper, and place first two holes on each side over tractor pins. Here is a summary of the micrpline active in the Menu Mode: In the case of USB interface cable 1. Every effort has been made to ensure that the information in this document is complete, accurate and up-to-date.

Hold the knob and remove the paper separator. Page Appendix D: Page 41 Summary of Menu Settings The table below details the entries in the printer Menu as it comes from the factory.

OKI Microline 9 Pin Dot Matrix Printer

Turn off printer 2. Page 71 Accessories You can add even more flexibility to your printer by means of the following optional accessories.

Paper separator Pull-up roller assembly 5. Removing Shipping Retainers Tab 1.

MICROLINE 721 Plus

Be sure to tighten screws on both ends of cable to keep it in place. Page 12 Knob Paper separator " "mark 3. Page 30 Switching Paper Paths To switch from continuous-form feed from the rear or bottom optional push or pull tractor installed micrline the printer to single-sheet feed from the top: Be careful if you use this feature: Push Tractor, Bottom-Feed Converts printer for feeding continuousform paper from the bottom.

Lower front end of cartridge over printhead until it snaps into place. Press to bring the paper down to the print position. Page 28 Paper Handling Your printer has several handy paper handling features: Remove plastic covering over opening for serial board in back panel:.

Connect suitable interface cable must be purchased separately to printer connector and to micrkline port of your computer. If desired, change TOF setting using control panel: Single Sheet Feed Jams To remove jammed single sheets of paper top feed: By inserting board to the far end, it is locked by the lock piece inside.